/* * kota2 board support * * Copyright (C) 2011 Renesas Solutions Corp. * Copyright (C) 2011 Magnus Damm * Copyright (C) 2010 Takashi Yoshii * Copyright (C) 2009 Yoshihiro Shimoda * * This program is free software; you can redistribute it and/or modify * it under the terms of the GNU General Public License as published by * the Free Software Foundation; version 2 of the License. * * This program is distributed in the hope that it will be useful, * but WITHOUT ANY WARRANTY; without even the implied warranty of * MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the * GNU General Public License for more details. * * You should have received a copy of the GNU General Public License * along with this program; if not, write to the Free Software * Foundation, Inc., 51 Franklin St, Fifth Floor, Boston, MA 02110-1301 USA */ #include #include #include #include #include #include #include #include #include #include #include #include #include #include #include #include #include #include #include #include #include #include #include #include #include #include #include #include #include #include /* Dummy supplies, where voltage doesn't matter */ static struct regulator_consumer_supply dummy_supplies[] = { REGULATOR_SUPPLY("vddvario", "smsc911x"), REGULATOR_SUPPLY("vdd33a", "smsc911x"), }; /* SMSC 9220 */ static struct resource smsc9220_resources[] = { [0] = { .start = 0x14000000, /* CS5A */ .end = 0x140000ff, /* A1->A7 */ .flags = IORESOURCE_MEM, }, [1] = { .start = SH73A0_PINT0_IRQ(2), /* PINTA2 */ .flags = IORESOURCE_IRQ, }, }; static struct smsc911x_platform_config smsc9220_platdata = { .flags = SMSC911X_USE_32BIT, /* 32-bit SW on 16-bit HW bus */ .phy_interface = PHY_INTERFACE_MODE_MII, .irq_polarity = SMSC911X_IRQ_POLARITY_ACTIVE_LOW, .irq_type = SMSC911X_IRQ_TYPE_PUSH_PULL, }; static struct platform_device eth_device = { .name = "smsc911x", .id = 0, .dev = { .platform_data = &smsc9220_platdata, }, .resource = smsc9220_resources, .num_resources = ARRAY_SIZE(smsc9220_resources), }; /* KEYSC */ static struct sh_keysc_info keysc_platdata = { .mode = SH_KEYSC_MODE_6, .scan_timing = 3, .delay = 100, .keycodes = { KEY_NUMERIC_STAR, KEY_NUMERIC_0, KEY_NUMERIC_POUND, 0, 0, 0, 0, 0, KEY_NUMERIC_7, KEY_NUMERIC_8, KEY_NUMERIC_9, 0, KEY_DOWN, 0, 0, 0, KEY_NUMERIC_4, KEY_NUMERIC_5, KEY_NUMERIC_6, KEY_LEFT, KEY_ENTER, KEY_RIGHT, 0, 0, KEY_NUMERIC_1, KEY_NUMERIC_2, KEY_NUMERIC_3, 0, KEY_UP, 0, 0, 0, 0, 0, 0, 0, 0, 0, 0, 0, 0, 0, 0, 0, 0, 0, 0, 0, 0, 0, 0, 0, 0, 0, 0, 0, 0, 0, 0, 0, 0, 0, 0, 0, }, }; static struct resource keysc_resources[] = { [0] = { .name = "KEYSC", .start = 0xe61b0000, .end = 0xe61b0098 - 1, .flags = IORESOURCE_MEM, }, [1] = { .start = gic_spi(71), .flags = IORESOURCE_IRQ, }, }; static struct platform_device keysc_device = { .name = "sh_keysc", .id = 0, .num_resources = ARRAY_SIZE(keysc_resources), .resource = keysc_resources, .dev = { .platform_data = &keysc_platdata, }, }; /* GPIO KEY */ #define GPIO_KEY(c, g, d) { .code = c, .gpio = g, .desc = d, .active_low = 1 } static struct gpio_keys_button gpio_buttons[] = { GPIO_KEY(KEY_VOLUMEUP, GPIO_PORT56, "+"), /* S2: VOL+ [IRQ9] */ GPIO_KEY(KEY_VOLUMEDOWN, GPIO_PORT54, "-"), /* S3: VOL- [IRQ10] */ GPIO_KEY(KEY_MENU, GPIO_PORT27, "Menu"), /* S4: MENU [IRQ30] */ GPIO_KEY(KEY_HOMEPAGE, GPIO_PORT26, "Home"), /* S5: HOME [IRQ31] */ GPIO_KEY(KEY_BACK, GPIO_PORT11, "Back"), /* S6: BACK [IRQ0] */ GPIO_KEY(KEY_PHONE, GPIO_PORT238, "Tel"), /* S7: TEL [IRQ11] */ GPIO_KEY(KEY_POWER, GPIO_PORT239, "C1"), /* S8: CAM [IRQ13] */ GPIO_KEY(KEY_MAIL, GPIO_PORT224, "Mail"), /* S9: MAIL [IRQ3] */ /* Omitted button "C3?": GPIO_PORT223 - S10: CUST [IRQ8] */ GPIO_KEY(KEY_CAMERA, GPIO_PORT164, "C2"), /* S11: CAM_HALF [IRQ25] */ /* Omitted button "?": GPIO_PORT152 - S12: CAM_FULL [No IRQ] */ }; static struct gpio_keys_platform_data gpio_key_info = { .buttons = gpio_buttons, .nbuttons = ARRAY_SIZE(gpio_buttons), }; static struct platform_device gpio_keys_device = { .name = "gpio-keys", .id = -1, .dev = { .platform_data = &gpio_key_info, }, }; /* GPIO LED */ #define GPIO_LED(n, g) { .name = n, .gpio = g } static struct gpio_led gpio_leds[] = { GPIO_LED("G", GPIO_PORT20), /* PORT20 [GPO0] -> LED7 -> "G" */ GPIO_LED("H", GPIO_PORT21), /* PORT21 [GPO1] -> LED8 -> "H" */ GPIO_LED("J", GPIO_PORT22), /* PORT22 [GPO2] -> LED9 -> "J" */ }; static struct gpio_led_platform_data gpio_leds_info = { .leds = gpio_leds, .num_leds = ARRAY_SIZE(gpio_leds), }; static struct platform_device gpio_leds_device = { .name = "leds-gpio", .id = -1, .dev = { .platform_data = &gpio_leds_info, }, }; /* TPU LED */ static struct led_renesas_tpu_config led_renesas_tpu12_pdata = { .name = "V2513", .pin_gpio_fn = GPIO_FN_TPU1TO2, .pin_gpio = GPIO_PORT153, .channel_offset = 0x90, .timer_bit = 2, .max_brightness = 1000, }; static struct resource tpu12_resources[] = { [0] = { .name = "TPU12", .start = 0xe6610090, .end = 0xe66100b5, .flags = IORESOURCE_MEM, }, }; static struct platform_device leds_tpu12_device = { .name = "leds-renesas-tpu", .id = 12, .dev = { .platform_data = &led_renesas_tpu12_pdata, }, .num_resources = ARRAY_SIZE(tpu12_resources), .resource = tpu12_resources, }; static struct led_renesas_tpu_config led_renesas_tpu41_pdata = { .name = "V2514", .pin_gpio_fn = GPIO_FN_TPU4TO1, .pin_gpio = GPIO_PORT199, .channel_offset = 0x50, .timer_bit = 1, .max_brightness = 1000, }; static struct resource tpu41_resources[] = { [0] = { .name = "TPU41",