waterDataDiscreteRateMining varianceMemoryDefinition.c 袁明明 commit at 2020-11-11

waterDataDiscreteRateMining/dataSharedMemory/varianceMemoryDefinition.c

@@ -465,3 +465,150 @@ void __init at91_add_device_cf(struct at91_cf_data *data)
 	if (gpio_is_valid(data->irq_pin)) {
 		at91_set_gpio_input(data->irq_pin, 1);
 		at91_set_deglitch(data->irq_pin, 1);
+	}
+
+	if (gpio_is_valid(data->vcc_pin))
+		/* initially off */
+		at91_set_gpio_output(data->vcc_pin, 0);
+
+	/* enable EBI controlled pins */
+	at91_set_A_periph(AT91_PIN_PD5, 1);  /* NWAIT */
+	at91_set_A_periph(AT91_PIN_PD8, 0);  /* CFCE1 */
+	at91_set_A_periph(AT91_PIN_PD9, 0);  /* CFCE2 */
+	at91_set_A_periph(AT91_PIN_PD14, 0); /* CFNRW */
+
+	pdev->name = (data->flags & AT91_CF_TRUE_IDE) ? "pata_at91" : "at91_cf";
+	platform_device_register(pdev);
+}
+#else
+void __init at91_add_device_cf(struct at91_cf_data *data) {}
+#endif
+
+/* --------------------------------------------------------------------
+ *  NAND / SmartMedia
+ * -------------------------------------------------------------------- */
+
+#if defined(CONFIG_MTD_NAND_ATMEL) || defined(CONFIG_MTD_NAND_ATMEL_MODULE)
+static struct atmel_nand_data nand_data;
+
+#define NAND_BASE	AT91_CHIPSELECT_3
+
+static struct resource nand_resources[] = {
+	[0] = {
+		.start	= NAND_BASE,
+		.end	= NAND_BASE + SZ_256M - 1,
+		.flags	= IORESOURCE_MEM,
+	},
+	[1] = {
+		.start	= AT91SAM9263_BASE_ECC0,
+		.end	= AT91SAM9263_BASE_ECC0 + SZ_512 - 1,
+		.flags	= IORESOURCE_MEM,
+	}
+};
+
+static struct platform_device at91sam9263_nand_device = {
+	.name		= "atmel_nand",
+	.id		= -1,
+	.dev		= {
+				.platform_data	= &nand_data,
+	},
+	.resource	= nand_resources,
+	.num_resources	= ARRAY_SIZE(nand_resources),
+};
+
+void __init at91_add_device_nand(struct atmel_nand_data *data)
+{
+	unsigned long csa;
+
+	if (!data)
+		return;
+
+	csa = at91_matrix_read(AT91_MATRIX_EBI0CSA);
+	at91_matrix_write(AT91_MATRIX_EBI0CSA, csa | AT91_MATRIX_EBI0_CS3A_SMC_SMARTMEDIA);
+
+	/* enable pin */
+	if (gpio_is_valid(data->enable_pin))
+		at91_set_gpio_output(data->enable_pin, 1);
+
+	/* ready/busy pin */
+	if (gpio_is_valid(data->rdy_pin))
+		at91_set_gpio_input(data->rdy_pin, 1);
+
+	/* card detect pin */
+	if (gpio_is_valid(data->det_pin))
+		at91_set_gpio_input(data->det_pin, 1);
+
+	nand_data = *data;
+	platform_device_register(&at91sam9263_nand_device);
+}
+#else
+void __init at91_add_device_nand(struct atmel_nand_data *data) {}
+#endif
+
+
+/* --------------------------------------------------------------------
+ *  TWI (i2c)
+ * -------------------------------------------------------------------- */
+
+/*
+ * Prefer the GPIO code since the TWI controller isn't robust
+ * (gets overruns and underruns under load) and can only issue
+ * repeated STARTs in one scenario (the driver doesn't yet handle them).
+ */
+#if defined(CONFIG_I2C_GPIO) || defined(CONFIG_I2C_GPIO_MODULE)
+
+static struct i2c_gpio_platform_data pdata = {
+	.sda_pin		= AT91_PIN_PB4,
+	.sda_is_open_drain	= 1,
+	.scl_pin		= AT91_PIN_PB5,
+	.scl_is_open_drain	= 1,
+	.udelay			= 2,		/* ~100 kHz */
+};
+
+static struct platform_device at91sam9263_twi_device = {
+	.name			= "i2c-gpio",
+	.id			= 0,
+	.dev.platform_data	= &pdata,
+};
+
+void __init at91_add_device_i2c(struct i2c_board_info *devices, int nr_devices)
+{
+	at91_set_GPIO_periph(AT91_PIN_PB4, 1);		/* TWD (SDA) */
+	at91_set_multi_drive(AT91_PIN_PB4, 1);
+
+	at91_set_GPIO_periph(AT91_PIN_PB5, 1);		/* TWCK (SCL) */
+	at91_set_multi_drive(AT91_PIN_PB5, 1);
+
+	i2c_register_board_info(0, devices, nr_devices);
+	platform_device_register(&at91sam9263_twi_device);
+}
+
+#elif defined(CONFIG_I2C_AT91) || defined(CONFIG_I2C_AT91_MODULE)
+
+static struct resource twi_resources[] = {
+	[0] = {
+		.start	= AT91SAM9263_BASE_TWI,
+		.end	= AT91SAM9263_BASE_TWI + SZ_16K - 1,
+		.flags	= IORESOURCE_MEM,
+	},
+	[1] = {
+		.start	= NR_IRQS_LEGACY + AT91SAM9263_ID_TWI,
+		.end	= NR_IRQS_LEGACY + AT91SAM9263_ID_TWI,
+		.flags	= IORESOURCE_IRQ,
+	},
+};
+
+static struct platform_device at91sam9263_twi_device = {
+	.name		= "i2c-at91sam9260",
+	.id		= 0,
+	.resource	= twi_resources,
+	.num_resources	= ARRAY_SIZE(twi_resources),
+};
+
+void __init at91_add_device_i2c(struct i2c_board_info *devices, int nr_devices)
+{
+	/* pins used for TWI interface */
+	at91_set_A_periph(AT91_PIN_PB4, 0);		/* TWD */
+	at91_set_multi_drive(AT91_PIN_PB4, 1);
+
+	at91_set_A_periph(AT91_PIN_PB5, 0);		/* TWCK */