waterDataFluctuationCorrelation synchronousMemoryDatabase.c 袁明明 commit at 2021-02-22

waterDataFluctuationCorrelation/fluctuationCorrelationOfSprayEnd/synchronousMemoryDatabase.c

@@ -404,3 +404,127 @@ static struct platform_device da830_evm_nand_device = {
 	},
 	.num_resources	= ARRAY_SIZE(da830_evm_nand_resources),
 	.resource	= da830_evm_nand_resources,
+};
+
+static inline void da830_evm_init_nand(int mux_mode)
+{
+	int ret;
+
+	if (HAS_MMC) {
+		pr_warning("WARNING: both MMC/SD and NAND are "
+				"enabled, but they share AEMIF pins.\n"
+				"\tDisable MMC/SD for NAND support.\n");
+		return;
+	}
+
+	ret = davinci_cfg_reg_list(da830_evm_emif25_pins);
+	if (ret)
+		pr_warning("da830_evm_init: emif25 mux setup failed: %d\n",
+				ret);
+
+	ret = platform_device_register(&da830_evm_nand_device);
+	if (ret)
+		pr_warning("da830_evm_init: NAND device not registered.\n");
+
+	gpio_direction_output(mux_mode, 1);
+}
+#else
+static inline void da830_evm_init_nand(int mux_mode) { }
+#endif
+
+#ifdef CONFIG_DA830_UI_LCD
+static inline void da830_evm_init_lcdc(int mux_mode)
+{
+	int ret;
+
+	ret = davinci_cfg_reg_list(da830_lcdcntl_pins);
+	if (ret)
+		pr_warning("da830_evm_init: lcdcntl mux setup failed: %d\n",
+				ret);
+
+	ret = da8xx_register_lcdc(&sharp_lcd035q3dg01_pdata);
+	if (ret)
+		pr_warning("da830_evm_init: lcd setup failed: %d\n", ret);
+
+	gpio_direction_output(mux_mode, 0);
+}
+#else
+static inline void da830_evm_init_lcdc(int mux_mode) { }
+#endif
+
+static struct at24_platform_data da830_evm_i2c_eeprom_info = {
+	.byte_len	= SZ_256K / 8,
+	.page_size	= 64,
+	.flags		= AT24_FLAG_ADDR16,
+	.setup		= davinci_get_mac_addr,
+	.context	= (void *)0x7f00,
+};
+
+static int __init da830_evm_ui_expander_setup(struct i2c_client *client,
+		int gpio, unsigned ngpio, void *context)
+{
+	gpio_request(gpio + 6, "UI MUX_MODE");
+
+	/* Drive mux mode low to match the default without UI card */
+	gpio_direction_output(gpio + 6, 0);
+
+	da830_evm_init_lcdc(gpio + 6);
+
+	da830_evm_init_nand(gpio + 6);
+
+	return 0;
+}
+
+static int da830_evm_ui_expander_teardown(struct i2c_client *client, int gpio,
+		unsigned ngpio, void *context)
+{
+	gpio_free(gpio + 6);
+	return 0;
+}
+
+static struct pcf857x_platform_data __initdata da830_evm_ui_expander_info = {
+	.gpio_base	= DAVINCI_N_GPIO,
+	.setup		= da830_evm_ui_expander_setup,
+	.teardown	= da830_evm_ui_expander_teardown,
+};
+
+static struct i2c_board_info __initdata da830_evm_i2c_devices[] = {
+	{
+		I2C_BOARD_INFO("24c256", 0x50),
+		.platform_data	= &da830_evm_i2c_eeprom_info,
+	},
+	{
+		I2C_BOARD_INFO("tlv320aic3x", 0x18),
+	},
+	{
+		I2C_BOARD_INFO("pcf8574", 0x3f),
+		.platform_data	= &da830_evm_ui_expander_info,
+	},
+};
+
+static struct davinci_i2c_platform_data da830_evm_i2c_0_pdata = {
+	.bus_freq	= 100,	/* kHz */
+	.bus_delay	= 0,	/* usec */
+};
+
+/*
+ * The following EDMA channels/slots are not being used by drivers (for
+ * example: Timer, GPIO, UART events etc) on da830/omap-l137 EVM, hence
+ * they are being reserved for codecs on the DSP side.
+ */
+static const s16 da830_dma_rsv_chans[][2] = {
+	/* (offset, number) */
+	{ 8,  2},
+	{12,  2},
+	{24,  4},
+	{30,  2},
+	{-1, -1}
+};
+
+static const s16 da830_dma_rsv_slots[][2] = {
+	/* (offset, number) */
+	{ 8,  2},
+	{12,  2},
+	{24,  4},
+	{30, 26},
+	{-1, -1}